Can you reprogram a 307 remote key

Stack Overflow for Teams — Collaborate and share knowledge with a private group. Create a free Team What is Teams? Learn more. Peugeot fob buttons central locking not working Ask Question. Asked 3 years, 6 months ago. Active 2 years, 4 months ago.

Viewed 57k times. Improve this question. Anna Anna 1 1 1 gold badge 1 1 silver badge 1 1 bronze badge. Welcome to the site. Typically new remotes require being linked to the car. So, take the remote back to who sold it to you and either have them make it work, or get your money back. I can't take it back- it was bought from private person who will not take it back Any other ideas? Thought it was a retail outlet that sold you the new remote.

No, my apologies- Timpson is a key cutting place. Remote is working as it been tested, its just not linked to my car The place that sold it to you should have linked it to the car for you. I will offer some suggestions in an answer below. Add a comment. Active Oldest Votes. Remove the key and wait for 10 seconds Press the lock button, the dash lights should come on Note: You will need to do this for each key you have that is not working.

Improve this answer. DavidSupportsMonica 2, 1 1 gold badge 13 13 silver badges 26 26 bronze badges. Here is another site with some instructions how to deal with central locking on a Peugeot. I have tried the first option numerous times and is not working I will try the others this evening Not trying to be too pedantic, but in the answer given, you cannot perform step 4 without having first turned the key to the OFF position.

After 5 seconds, Plip should now operate. After 20 seconds press the small deadlock button once while still holding the large button. The LED will stop flashing. Release the large button and the LED will light constantly. Press the large button one time, and the LED will go out. Open the door and hold the Plip key near the Ignition switch, and press the large plip button one time. Turn the Ignition switch to accessory position using the key, without the remote plip attached.

Hold the Plip key close to the central locking receiver mounted in the roof console. Press the large plip button, then the small plip button on the remote. Repeat for second Plip key if required. Turn ignition OFF. The deadlocking remote control has specific button controls, and if the vehicles has two controls, one is set as primary and the other as secondary.

When replacing the Plip, a Primary or Secondary Plip are different part numbers and must be ordered as required. Procedure 1. Turn the Ignition switch ON. Press the large Plip key button Primary Plip 3. Within 10 seconds, press the large Plip key button Secondary Plip 4. If there is one remote, press the Primary plip button twice.

NOTE: On some models, Plips cannot be re-synchronised unless the battery has been disconnected for 1 minute. Hold the Plip key towards the receiver at the front of the vehicle. Turn the Ignition switch to ON position using the first key.